Hey guys,
At the moment I'm trying to setup LIRC with a TSOP4838 and a rpi3 for the xbox one remote. I followed following guide: "How To Setup LIRC GPIO IR Remote Control [..]"
Despite the fact that I can successfully record the keys with
Code
irrecord -d /dev/lirc0 lircd.conf
and copying the generated file to /storage/.config I dont get any output when I run (after rebooting) irw.
Here is what I tried/verified:
- Checked if mode2 -d /dev/lirc0 prints an output (should indeed succeed because i can record keys).
- dmesg output is as in the tutorial described.
- Tried another TSOP4838 (just to be sure that the sensor works correctly).
- Reran irrecord
- Disabled CEC (both TV+kodi)
I'm stucked at this point now. Any help would be greatly appreciated!
Thank you in advance.
PS: I'm using LibreELEC 8.0.0 and the GPIO IR is running at 3.3V.
Edit[1]: dmesg output
Code
dmesg | grep lirc
[ 3.403009] lirc_dev: IR Remote Control driver registered, major 244
[ 3.433801] lirc_rpi: module is from the staging directory, the quality is unknown, you have been warned.
[ 4.365051] lirc_rpi: auto-detected active low receiver on GPIO pin 18
[ 4.365264] lirc_rpi lirc_rpi: lirc_dev: driver lirc_rpi registered at minor = 0
[ 4.365266] lirc_rpi: driver registered!
[ 4.572002] input: lircd-uinput as /devices/virtual/input/input0
[ 4.703367] input: eventlircd as /devices/virtual/input/input1
