Check your LNB settings and make sure you only enable one tuner at a time.
OK. Thanks. It runs fine now. I have scanned the two DVB, and have the complete service list of the two DVB.
So I cannot see DVB-S or DVB-T without put enable any tuner automatically ??? Cannot switch TVHeadend it auto ???
Thanks.
AGAIN !!!
Pls, report exact versions and dvb (e.g. dvb-t2, dvb-s2, ...) otherwise this info is for nothing.
I install this version ( LibreELEC-S905.arm-8.0-devel-7.95.beta6Y-20170216132010.img.gz - beta 6y) on USB to run (I dont like SD Card, cause are too slow). Put TvHeadend, and dvb-t runs perfectly it scans right, but cannot scan on dvb-s. I dont know why 
I use KII-Pro.
Thanks.
I use cccam reader. In both case with the same reader settings.
Maybe in this case somehow disabled the cccam reader?
:
"restarting decodingrequests after 0 ms with 1 enabled and 3 disabled ecmpids"
what mean disabled ecmpids?
or with LE8 will disabled the cccam protocol?
I use OSCAM using 4 CCCAM lines from a provider, and works fine on version I use: LibreELEC-S905.arm-8.0-devel-7.95.beta6-20170212173536.img.gz
I have KII-Pro box.
Only have problems on Tvheadend viewing streaming LAN at home (tablets and phones), when view HD channels (pixelates too much).
Good luck.
