Yes you can, set it up through the LibreELEC settings addon.
Posts by escalade
-
-
Actually I think those CPU's aren't even close to be able to run PCSX2 at a meaningful speed. It's more demanding than Dolphin.
-
Works here. Does the remote server have a working RPC/NFS service?
-
You're asking on the wrong forum, this is LibreELEC not OSMC.
-
The module autoloading in the last version got messed up, I've removed the broken build and a new one is uploading quite soon.
You could remedy it by doing CTRL+ALT+3 and copying an update file from a USB connected drive to /storage/.update and rebooting.
-
If you read my replies one page back you'd already know that.
-
My receiver supports HD audio, but I just use PCM nowadays to be able to control the volume. There's zero difference as far as I can tell.
-
Uploaded 20170912. Relevant changes are updated Dolphin and 4.13.1 kernel.
-
Well, you're really not clear on OpenVPN as you just asked how you could install LibreELEC through it
-
1. Chromecast is not a supported device, so no.
2. OpenVPN is just VPN software, it does not aid in installing LibreELEC at all.
-
It doesn't make sense as LE supports SMB1+2+3 server side.
-
If that was necessary, then you haven't followed the instructions in the release notes. You probably have an old samba.conf on the LE system you are connecting to.
-
It includes only the necessary bits of an OS to run Kodi, nothing more nothing less.
-
I know it's more secure but not everyone knows what these settings are for and how to find them...My main issue is that with default settings you can't see 2 LE machines on same network...1 is a Rpi2 and the other HP laptop...So from the laptop couldnt see the Rpi with default settings and mounts failed with min smb2 setting..I think it's a good idea if smb settings are in just 1 place...thanks for your hard work and help chewitt
Edit:the smb setting on kodi services didn't help...it was the new setting in the LE addon that enabled the network between my machines
Yes you can, browsing works if you use zeroconf and not windows network.
-
Try again, I missed the 32-bit nvidia libraries.
-
Probably because I didn't add nvidia drivers to the Docker image. I've updated the image now, can you do a docker pull escalade1/arch ; docker pull escalade1/arch-pcsx2 through ssh and then try again? If that doesn't work you could switch to software opengl through running pcsx2.sh and then configure the gsdx plugin.
-
Don't know what's going on with that, no RPi here to test. You could update manually by writing the image to a USB, then copy over SYSTEM/KERNEL to your /flash.
-
Same way you get other addons. I use Dolphin, the standalone version (built from git). The RetroArch core is experimental and under development, I'm not sure about the status but the standalone version should be the best experience at the moment.
