Display MoreThanks to ilmich for his hard work.
This build of LibreElec 10.0 works amazingly well, but I have some issues:- HDMI resolutions are incorrect
- No audio from HDMI
I put two pics of the boxes: AFAIK they have eMMC (Samsung part, 8Gb), rk3228a & 533Mhz DDR3. On the board is written V3.1.
They have South valley SSV6051 wifi (not really important).
Actually, your build is the ONLY one that does not crash after one/two hours of video, too bad I do not have any audio, and I don't know where to look for a fix. HDMI driver loads fine, but it seems ALSA device is not detected. Here's what I read in dmesg:
[ 2.108808] ALSA device list:[ 2.108828] No soundcards found.
I suspect that the previous RockChip 4.4 "legacy" Kernel was really buggy in the video hw accelerator part (rkmpp was hanging/spewing errors all the time) or maybe somethng else was wrong. Hard to say with these parts.
Even the Armbian build was giving the same errors with rkmpp video hw stack, and kept switching to software decoding after 5/6 minutes of video play.
This build works really well with an hardware SO low-spec. The original android 7.1 NEVER worked, hanged after half an hour. I bought 10 of those for €9, since they were marked "defective" (and for good reasons).
The "overclock" m4kpro dtb file works pretty well, even after two/three hours of video play (lan/udp streaming of a full HD webcam via ffmpeg).
Thanks again for giving some use to an hardware so limited.
hi, I have the same board as You -R329Q_V3.1, the stick RK329 and my opinion also the chip rk3228A should be the same but I can't confirm it because I don't want have problem removing the heat dissipation - can You tell me how do You have found ir protocol used ?