Posts by FrozenEternity

  • Connman config reverting on reboot (RPI3)

    I have wifi and ethernet connected and I am attempting to follow the steps on this post to create a bridge so that the VPN on Libreelec can be shared over wifi

    Thread

    How to setup a bridge from Wi-fi to Ethernet?

    Hi,


    I have Libreelec installed on a Rpi4, which is connected to the Internet via Wi-fi. I would like to create a bridge so that this Wi-fi connection is bridged to the Ethernet port. I'm not sure if it is feasible, even using command lines, as Libreelec has limited network configuration capabilities, even with Network tools addon installed.

    How could I do this?

    Thanks.

    Regards.
    Alomon
    May 11, 2021 at 2:07 PM

    I use SSH via Putty and edit the config file and save with ^O. I then can go back and check the config and see the changes I have made. Once I reboot the Libreelec device these changes are gone.

    I have set the WAN connection to manual on the Libreelec kodi addon. This setting does not reset.

    I am new to this and feel I am missing something fundamental. Any help would be greatly appreciated!