Posts by og13

og13 · DIGI+ PRO not working with PI4B og13 November 23, 2020 at 4:32 PM

Thanks for all. Since, i tried an PIFI DIGI+ card and it works now.

og13 · DIGI+ PRO not working with PI4B og13 November 15, 2020 at 4:19 PM

Indeed, i 'am afraid that's so, even if these cards have same hardware.

Thanks for all

og13 · DIGI+ PRO not working with PI4B og13 November 15, 2020 at 8:45 AM

Hi,

I have a problem with an AOIDE DIGI Pro soundcard (DIGI+ PRo clone card) wich is working fine on pi3B.

I tested on several OS like volumio, libreelec and raspbian but always the same issue with pi4B.

kodi.log

og13 · Should I change to Rpi 4B? og13 November 15, 2020 at 8:32 AM

HiassofT : I did all this hardware verification with multimeter.

All is ok.

The soundcard works with PI3B.

It seems to be an timing issue that let the W8804 in hw mode instead sw mode : https://forum.libreelec.tv/thread/21767-s…6343#post146343

Da Flex : I do it now

og13 · Should I change to Rpi 4B? og13 November 14, 2020 at 7:34 PM

Da Flex

The same issue

The right topic i talked before : https://forum.libreelec.tv

og13 · Should I change to Rpi 4B? og13 November 14, 2020 at 6:55 PM

I found on this topic an explication of the issue https://forum.libreelec.tv

og13 · Should I change to Rpi 4B? og13 November 14, 2020 at 6:51 PM

I just do it but same issue

og13 · Should I change to Rpi 4B? og13 November 14, 2020 at 6:37 PM

Yes i did (i think so).

Part of config.txt :

################################################################################

# End of default configuration

################################################################################

dtdebug=1

dtparam=i2c_arm=on

dtparam=i2s=on

# dtparam=audio=off

dtoverlay=hifiberry-digi-pro

################################################################################

dmesg

[ 5.105402] snd-rpi-wm8804 soc:sound: ASoC: CODEC DAI wm8804-spdif not registered - will retry

[ 5.107082] snd-rpi-wm8804 soc:sound: ASoC: CODEC DAI wm8804-spdif not registered - will retry

[ 5.241405] wm8804 1-003b: Linked as a consumer to regulator.1

[ 5.242057] wm8804 1-003b: Failed to read device ID: -121

[ 5.242252] wm8804: probe of 1-003b failed with error -121

og13 · Should I change to Rpi 4B? og13 November 14, 2020 at 6:12 PM

Hi,

I have a P4B with the last Libreelec installed.

To get better and 5.1 sounds with my home cinema amplifier, i bought a DIGI+PRO soundcard. After many tests and reading topics, it's not posible to use these soundcards with PI4. I seems to be an issue from the driver. We have to wait for ...