Posts by TimboZero

Thank you for your reply Chewitt.

This hotspot would for example allow say an iPhone in that room access to the fibre network via said hotspot through to the LAN as if the phone was a wired device?

Edit: the phone is in fact the only Wi-Fi device that I’d like to grant ‘better’ access to my network, the walls in my house are stone and thick enough to make it connected but weakly. I understand the warning about (even if I used same ssid and password) it wouldn’t transition seamlessly and whilst this is a shame it’s not a problem (to be honest maybe better as then I could use a separate ssid and password)

To be honest this would be an extra value thing to save the bother of building a Mesh

I have read so much on this in the last 24h that it has baffled me.

I know it’s possible but the question is….

I am upgrading my backup Kodi box to a RPi4 2GB (which arrives tomorrow) and will get Libreelec, the GPIO 18 IR led setup and then the 2TB HDD of some media stuff. That part I all know about and 100% comfortable with.

The RPi4 will be connected to my network via its LAN port, leaving its onboard Wi-Fi doing nothing. Can I set this to be an access point (same ssid and password) as my main fibre box to make the Wi-Fi in that room stronger?

And assuming yes, how?

Many thanks for reading and any help offered.

I have been reading

http://gist.github.com/coaxial/575fec…86e419b97927eb8

and

https://wiki.libreelec.tv/configuration/ir-remotes

and so far not had any success

please someone help

I hate to bump my own post but I am desperate for a solution.

Please anyone able to assist?

Good day to you all,

Last night I upgraded my rPi3 from 9.2.4 to 10.0.2 via the download an patch method in the UI, not a fresh install.

Nearly everything went perfectly except my previously working XBox One media remote no longer works.

I suspect the lircd.conf file needs to be replaced but I can’t for the life of me find where it should be (storage/.config rings a bell from last time???) or what the contents of the file should be.

Any kind soul able to help out with a file and where it should go please?

Many thanks

Timbo

That’s perfect, thanks so much.

Big wiki, complete but tough for a newb like me to find relevant parts.

Your help has been invaluable:)

Update, did as told and all working beautifully. Thank you so much Hias.

Still, it’s persistent through reboots and updates ?

Good day Hias, thank you for the reply.

OK, so Lirc.conf deleted.

Then from SSH just run

ir-keytable -c -w /usr/lib/udev/rc_keymaps/xbox_one

And I should be good to go?

I assume this keymap is persistent and I won’t need to do it every reboot?

Thanks

Timbo

Good day Libreelecians,

I have just installed an IR diode to 3.3,GND and GPIO 18 on my Raspberry Pi 3.

I have then created (as it didnt exist) /storage/.config/lircd.conf and saved it

I understand the next step is to change a line in /flash/config.txt, but this line did not exist so I have added the line dtoverlay-gpio-ir

As far as I know this is all I need to 'activate' my IR diode and let Kodi use it (FYI latest stable build of Libreelec 9)?

I wish to use this IR receiver with an XBox One mini media remote

Do I need to load up a config for this and if so how please ?