Code
#*********************************************************************************************************
#this file is configuration for each factory remote device
# work_mode 0 :software mode 1 :hardware mode
# repeat_enable 0 :disable repeat 1 :enable repeat
#
# factory_code each device has it's unique factory code.
# pattern:custom_code(16bit)+index_code(16bit)
# examble: 0xff000001 = 0xff00(custom cod) 0001 (index)
#
# release_delay unit:ms.release will report from kernel to user layer after this period of time
# from press or repeat triggered.
#
# debug_enable 0 :debug disable 1 :debug disable
#
# SW MODE:
# bit_count how many bits in each frame
# tw_leader_act time window for leader active
# tw_bit0 time window for bit0 time.
# tw_bit1 time window for bit1 time
# tw_repeat_leader time window for repeat leader
# REG
# reg_base_gen set value for PREG_IR_DEC_BASE_GEN
# reg_control set value for PREG_IR_DEC_CONTROL
# reg_leader_act set value for PREG_IR_DEC_LEADER_ACTIVE
# reg_leader_idle set value for PREG_IR_DEC_LEADER_IDLE
# reg_repeat_leader set value for PREG_IR_DEC_REPEAT_IDLE
# reg_bit0_time set value for PREG_IR_DEC_BIT0_TIME
#*************************************************************************************************************
#amlogic NEC remote
work_mode = 0
repeat_enable = 1
repeat_delay = 130
repeat_peroid = 120
release_delay = 20
debug_enable = 1
#fn_key_scancode = 0x48
#left_key_scancode = 0x51
#right_key_scancode = 0x50
#up_key_scancode = 0x16
#down_key_scancode = 0x1a
#ok_key_scancode = 0x13
#pageup_key_scancode = 0x04
#pagedown_key_scancode = 0x1b
custom_begin
factory_infcode = 0
factory_code = 0x7f800001 # M96X mini
mouse_begin
#0 0x51 //mouse key left
#1 0x50 //mouse key right
#2 0x16 //mouse key up
#3 0x1a //mouse key down
mouse_end
key_begin
0x73 102 #HOME
0x27 158 #EXIT
0x83 125 #MENU
0x81 116 #ON/OFF
0x87 115 #VOL+
0x89 114 #VOL-
0x38 103 #UP
0x37 105 #LEFT
0x13 28 #DPAD_CENTER
0x39 106 #RIGHT
0x40 108 #DOWN
0x48 109 #PAGEDOWN (was MOUSE)
key_end
repeat_key_begin
repeat_key_end
custom_end