Posts by Pieman007

I've tried the setting the resolution - pressing right then OK to select Yes to Keep this resolution - I then pulled the plug on the Pi and the Amp, reapplied power the same behaviour was observed....i.e. 1080 on the Pi colour screen and the Pi Recovery screen then nothing

So plugging in to the HDMI port on the TV and switching the display to 1920x1080p (first and second options) successfully displays. TV reports 50Hz and 60Hz.

One thing I noted was when I reboot the box and the "colour" startup screen is shown its does show and the TV says "1080p" .....

The Amp is a Yamaha RX-V667. Checking the firmware of the device its running 2.04. The latest I can see is 2.05 which according to the PDF "

This firmware improves stability with 3D signals from DirecTV set-top boxes"....that was September 2010.

I will try a different HDMI port on the Amp.

Apols for the delay......log uploaded here :

Steps done

Resolution set to 1280x720p in Settings - System - Display

Log put into debug mode

Rebooted device

Settings - System - Display = set device to 1920x1080p (first one)

Screen goes blank - leave it for 15 seconds press Enter (so the Keep resolution is NO)

Set device to 1920x1080p (second one)

Screen goes blank - leave it for 15 seconds press Enter (so the Keep resolution is NO)

Exit Settings

Cancel Debug

Thanks will get and post

Hi All

Been a reader and found fixes for some of the issues I've been experiencing with setting up a Rasp Pi 4B 2GB (audio etc!)

The problem I have and can't seem to fix is getting the Kodi interface to display in 1080p. My setup is Rasp Pi 4B (2GB) - HDMI into Amp - then the HDMI out port on the Amp into the TV. I have a Blu-Ray / DVD-Recorder / Virgin Media Cable box / Now TV box all going into the Amp.

When the Pi boots up - the TV shows the input as being received as 1080p/50Hz. Kodi starts up and it shows as 720p/50Hz. I go into Settings - System - Display and search one of the two 1920x1080p options; the screen goes black (there are no display changes on the Amp), and stays black. I tap the OK button on my (Pi) keyboard which corresponds to NO option on the "Do you want to keep this display resolution" so it returns to the Settings screen. I try the other 1920x1080p option and the same occurs.

From a config.txt file point of view following other issues (Sound) I have put hdmi_drive=2 in and the (Original) HDMI lead is in the port closest to the Power Lead (official Pi 4 power pack).

Any advice / assistance gratefully received......Thanks!