Posts by Aldrich

Aldrich · migrate RPi2 -> RPi3 freezes! Aldrich March 14, 2018 at 5:51 AM

hi milhouse,

good objection too! thx for the link.

Aldrich · migrate RPi2 -> RPi3 freezes! Aldrich March 12, 2018 at 6:53 AM

ok, I did a fresh install with all relevant settings at the weekend, and copied the following files from the old Pi2-backup to the new Pi3-installation:

.kodi/userdata/advancedsettings.xml

.kodi/userdata/mediasources.xml

.kodi/userdata/sources.xml

further, to enable my IR-remote:

.config/lircd.conf

.kodi/userdata/keymaps/remote.xml

.kodi/userdata/lircmap.xml

...and activate the module in config.txt

so far, everything seems fine......

Aldrich · migrate RPi2 -> RPi3 freezes! Aldrich March 8, 2018 at 6:05 AM

hi all,

I believe a clean install is the only ..bitter..way! A backup "restore" does not work under this circumstances, chewitt I read your post some minutes too late

So as jweaver mentioned, a guide which files are really needed will be great. Even though I suppose there are only a few like:

.kodi/userdata/* ?!

advancedsettings.xml

lircmap.xml (if you use it)

.addons (perhaps better fresh install)

.config?!

Aldrich · migrate RPi2 -> RPi3 freezes! Aldrich March 7, 2018 at 9:04 AM

til now I only tested my previous installation.

I just flashed a clean sd with a fresh LE 8.2.3 and give it a try later on.......

Aldrich · migrate RPi2 -> RPi3 freezes! Aldrich March 7, 2018 at 7:04 AM

Hi all,

I'm running a RPi2 with current LE (static IP, the database is on a connected mariadb@synology).

Yesterday I swapped the RPi2-board with a RPi3 model, the system booted, but freezed at the kodi splashscreen.

Swapping back to RPi2 all runs fine....

I can't check the logs of the RPi3 startup, because at this moment the system isn't online.

Any ideas to fix this?