Posts by Degemon

Degemon · Hyperion + WS2812B Degemon October 9, 2017 at 9:18 AM

Finaly its work with arduino nano! Thx guys for you answer. But i have some issues leds a little flicker and slowly. Who knows how fix that?

Degemon · Hyperion + WS2812B Degemon October 8, 2017 at 12:08 PM

I have one last idea, use arduino for this leds or just buy ws2801

Degemon · Hyperion + WS2812B Degemon October 7, 2017 at 8:54 PM

And this also nothing change(. I think it's enough, i will go to buy ws2801, or apa102...

Degemon · Hyperion + WS2812B Degemon October 7, 2017 at 12:41 PM

Quote from S80_UK

Good feedback. Your measurements indicate that the supply is probably OK. It was worth checking though. I can only guess at maybe a software or configuration issue. Sorry I cannot help more. I have no direct experience with Hyperion or Hypercon. It looks interesting though.

All ideas may help, thx for your participation.

I want to try use logic level converter (from 3.3 v to 5v), mb it can change the situation.

Degemon · Hyperion + WS2812B Degemon October 7, 2017 at 6:06 AM

Hello! Thx for your answer. I have 5v 10a power supply, when i use the multimeter i have diference between start and the end of strip about 0,06-0,08V (5.0 at start 4.94 at the end), i take this measure on full red strip.

It can be suuply issue if the rainbow effect still work? And one color lighting too.

Degemon · Hyperion + WS2812B Degemon October 6, 2017 at 9:40 PM

You're russian is not too bad 🙂.

I try to use addon and hypercon for le, and nothing changed. This looks like problem with grabber or something like this. Mb 12 pin of rpi3 does not have too much voltage to control leds. But if I chose all leds reds or green or blue, then all of them ligting up.

Degemon · Hyperion + WS2812B Degemon October 5, 2017 at 3:22 PM

Hello everybody. At first i want sorry for my english, i know it's bad, but i hope you can understand me.

I have system on RPi3 + LE + WS2812B, I'm using hypercon from hyperion-project syte to install and configure it on my RPi3 and i have some issues:

1) I have interface (kodi) stuck after 10-15 minutes when hyperion installed, and then the system unwant to start, in this case help only full reinstall of LE.

2) When i push "start" button in hypercon i saw rainbow effect and each of led are lighting up, but then working only 15-20 leds of 90 total. But if i chose set led color" all leds are working.

3) I cant find any explain what mean "Amount of LEDs" when i choose WS281x driver. If i think right, i must tape this the of all leds i using?